Delta VFD-V Series User Manual

5
VFD-V Series
DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED
5-25
Settings Functions Explanations
21
Pre-set counter value attained
Please refer to 02-16
22
Desired counter value attained
Please refer to 02-17
23
Heat sink overheat warning
Please refer to 06-15
24
Operation frequency attained 1 (both
directions)
25
Operation frequency attained 2 (both
directions)
26
Pre-set frequency attained 1 (both
directions)
27
Pre-set frequency attained 2 (forward
only)
28
Pre-set frequency attained 1 (both
directions)
29
Pre-set frequency attained 2 (forward
only)
30
Software braking output
Please refer to 07-00
31
Position Achieved
In position mode, position point can
output a position achieved signal by
setting this parameter. At this moment,
AC drive achieves position and motor is
in holding state.
32~47
PCO Step Indication
Corresponds to the 0~15 step speeds
48~63
Multi-step Indication
Corresponds to the 0~15 step speeds
64
PG Fault
65
PG Stall
69
Over-torque(oL3)
Please refer to 06-09
70
Zero speed (STOP)
71
Position synchronization 1 (10-10)
72
Position synchronization 2 (10-23)
In position mode, you can output a
position synchronization signal by
setting d71, d72 (please refer to 10-10,
10-23)
02-15 Multi-Function Output Direction
a
Factory setting 00000
Settings 0~15 (1 high)
This function uses the Bit setting method.

Delta VFD-V Series Specifications

General

Brand	Delta
Model	VFD-V Series
Category	Controller
Language	English