5
VFD-V Series
DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED
5-63
5.10 Group 9: Communication Parameter
09-00 Communication Address
a
Factory setting 1
Settings 1-254
When the system is controlling or monitoring with the RS-485 series connection
communication interface, every drive has to be determined with one communication
address then and that the address connected to the network should be specific and
could not be repeated.
09-01 Transmission Speed of the Communication
a
Factory setting 9.6
Settings 4.8~115.2 Kbits/Sec
Through the internal RS-485 series connection ports within the computer, users are to
set and revise the parameters within the drive, and to control the operation of the drive,
and further, to monitor the operation status of the drive. This parameter is utilized in
setting up the transmission speed between the computer and the drive.
09-02 Transmission Fault Treatment
a
Factory setting 3
Settings 0 warn and keep operating
1 warn and RAMP to stop
2 warn and COAST to stop
3 no treatment and no display
This parameter is utilized in setting the drive’s treatment toward transmission overtime fault
(e.g. when the communication cord is broken) during the communication.
09-03 Overtime Detection
a
Factory setting 0
Settings 0 disabled
1~100 Sec
This parameter is utilized in setting the transmission overtime between the
communication and the keypad.
09-04 Communication Protocol
a
Factory setting 1
Settings 0 to 17
To Next Page
Loading...
Need help?
General
