SPECIAL MODE
Special mode setting button (for E400E3 model)
b
No.1 - 5 , 7 : Press the "Power operation (
X
)" button to turn on the power while pressing both the buttons A, B and the button C at
the same time.
b
No.6 , 8 : Turn on the power, then press and hold down the A and B buttons for over 3 seconds.
b
No.9 : Turn on the power, then press and hold down the A and B buttons for over 10 seconds.
No. Mode Button A Button B Button C Contents
1
Version display
(μcom/DSP Error Display)
STATUS DIMMER –
Firmware versions such as Main or DSP are
displayed in the FL Display. Errors are displayed
when they occur. (Refer to 24 page)
2
User Initialization mode
(Installer Setup settings are not
initialized.)
SOURCE
SELECT
1
SOURCE
SELECT
0
–
Backup data initialization is carried out.
(Installer Setup settings are not initialized.)
3
Factory Initialization mode
(Installer Setup settings are also
initialized.)
ZONE2
SOURCE
DIMMER –
Backup data initialization is carried out.
(Installer Setup settings are also initialized.)
4
PANEL/REMOTE LOCK Selection
mode
ZONE2
SOURCE
SOURCE
SELECT
1
–
Selects to reject operations through panel buttons
and the master volume knob on the main unit and
operations via the remote control.
5 Service Related Selection mode
ZONE2
SOURCE
DIMMER STATUS
Selects the “Diagnostic mode” or “Displaying the
protection history mode”.
6 Remote ID Setup mode STATUS DIMMER –
When using multiple DENON AV receivers in the
same room, make this setting so that only the desired
AV receiver operates. (Refer to 50 page)
7 Protection pass mode
SOURCE
SELECT
0
STATUS
ZONE2
SOURCE
Turns the power on with the Protection detection
disabled.
8 DM860A Reboot mode
SOURCE
SELECT
1
SOURCE
SELECT
0
Restarts DM860.
9 NETWORK Initialization mode
ZONE2
SOURCE
DIMMER – Initializes NETWORK related settings.
STATUSZONE2 SOURCE
DIMMERX
SOURCE SELECT
0
SOURCE SELECT
1
22
To Next Page
Loading...
