Denon AVR-E400 Service Manual

51
7.2. Starting up
q
Turn on the power and switch to NETWORK FUNCTION.
w
Wait until ”No Network Connection” or ”Favorites” is displayed on FLD.
e
Press and hold "ZONE2 SOURCE" and "DIMMER".
r
When “Initializing” is displayed on FLD, release the buttons.
If it is not displayed within 15 seconds, try again from Step
e
.
t
Wait until ”No Network Connection” or ”Favorites” is displayed on FLD.
y
Press the "Power operation (
X
)" button to turn off and on the power.
q
FLD
N E T W O R K
w
FLD
N o N e t w o r k
NETWORK not connected.
FLD
F a v o r i t e s
NETWORK connected.
e
Press and hold "ZONE2 SOURCE" and "DIMMER".
r
FLD
I n i t i a l i z i n g . . .
t
FLD
N o N e t w o r k
NETWORK not connected.
FLD
F a v o r i t e s
NETWORK connected.
y
FLD
N E T W O R K
51

Denon AVR-E400 Specifications

General

HDMI Inputs	6
HDMI Outputs	1
3D Pass-through	Yes
4K Pass-through	Yes
Dolby TrueHD	Yes
DTS-HD Master Audio	Yes
Audyssey MultEQ	Yes
Network Connectivity	Yes
AirPlay	Yes
DLNA	Yes
Input Impedance	47 kOhms
Input Sensitivity	200 mV
Signal-To-Noise Ratio	100 dB
Response Bandwidth	10 Hz - 100 kHz
THD	0.08%
Tuner Presets	56
Tuner Bands	AM/FM
Frequency Response	10 Hz - 100 kHz
Video Upscaling	Yes
Bluetooth	No
Wi-Fi	No
Surround Sound Effects	DTS Neo:6
Audio D/A Converter	192kHz/24-bit
Inputs	HDMI, Digital Optical, Digital Coaxial, Analog
Outputs	HDMI, Headphones