EN-12 Originalbetriebsanleitung Allgemein
Warnings
▪ It is possible to change the size of the wheels on the
frame of your Pedelec if necessary. This will aect
the shutdown speed. Changes in wheel size should
only be performed in a specialist workshop using
the procedure provided, which has been approved
by us.
Seriousfallsandaccidentsduetoinsucientbicycle
control.
▪ Ask your cycle dealer to show you how to use
your bike and explain its special features and
components. Please also follow the component
guides 5. Component guides Page EN-10.
▪ Adjust the bicycle to your height
14.4 Configuring the individual settings Page EN-21.
▪ Pedelec: We recommend that only youngsters aged
14 and above be allowed to ride a Pedelec.
▪ Pedelec/S-Pedelec: Practice riding with the assist
function in a safe place before venturing into
trac. Ride in the lowest assist mode until you feel
condent enough to try the higher modes. Dismount
if you ever feel unsafe.
▪ Practise braking in a safe place before venturing
into road trac 23. Brakes Page EN-32.
▪ Adapt your riding style to the prevailing trac
conditions. Bear in mind that longer braking
distances are needed on wet or icy roads. Think
ahead in such circumstances, anticipating the
actions of other road users, and reduce your speed.
▪ Avoid sudden jerky movements of the handlebars
and braking actions. Dismount if you ever feel
unsafe.
▪ Be ready to brake, particularly in situations with
poor visibility, and when riding downhill.
▪ Never ride "hands free". You may suer a serious
fall, and will also be committing a misdemeanour, as
you are required by law to always have at least one
hand on the handlebars 7.4 Rules of conduct on the
Internet Page EN-14.
▪ Concentrate on the trac. Do not let yourself
become distracted by the display or your
smartphone. We do not recommend listening to
music on headphones while riding.
▪ Only use original replacement parts when replacing
components and consumer parts. In addition to
original replacement parts, you may also use
compatible components that have been expressly
approved by us.
▪ Replace any damaged or bent components before
using the bike again. Not doing so can lead to the
failure of essential parts.
Serious falls and accidents caused by detached or
broken components.
▪ Have all assembly and adjustment work done in a
specialist workshop. If you must
attach anything yourself, use an
appropriate torque wrench and
be sure to comply with the speci-
ed tightening torques 13.
Tightening torques for threaded
connections Page EN-19. Insuci-
ently tightened screws/nuts can
loosen, tear o or break. Exces-
sively tightened screws/nuts can damage the
components. The tightening torques are marked on
the components and in the operating instructions.
Tightening torques provided by a component
manufacturer shall take precedence over torque
values given in these operating instructions
5. Component guides Page EN-10.
Fig. 2 Torque wrench
Warnings
Seriousfallsandaccidentscausedbyinsucient
lighting.
▪ Do not ride in unfavourable lighting conditions
(fog, rain, dusk, darkness) without adequate lights
7. Legal requirements for use on public roads Page
EN-13.
▪ Pedelec/S-Pedelec: If your Pedelec/S-Pedelec is
tted with a backup light, we recommend keeping
this switched on at all times.
Serious injury caused by an exploding battery.
▪ Pedelec/S-Pedelec: Do not open up the battery.
Notices
Faulty components and lapsed warranty due to
improper repair.
▪ Contact your specialist workshop in the event of
any problems with components.
▪ Pedelec/S-Pedelec: Do not open up the motor,
display, control element or charger.
Damaged components because the bicycle was not
parkedsecurely,andfellover.
▪ Always park your bicycle so that it cannot tip over.
If your bike is not equipped with a kick stand, one
can be tted if required. Please contact your cycle
dealer.
Information
Pedelec/S-Pedelec: The A-weighted emission sound
pressure level is lower than 70 dB(A) at the cyclist’s
ears. This means that the noise emitted by the
Pedelec/S-Pedelec while in use does not exceed
70 dB(A).