Derby cycle Pedelec - 9 Description of Your Bicycle; Bicycle (Motorless; Pedelec; S-Pedelec

EN-16 Originalbetriebsanleitung Allgemein
9. Description of your bicycle
9.1 Bicycle (motorless)
A bicycle is a vehicle with a minimum of two wheels,
usually one behind the other. It is powered exclusively
by stepping on pedals, i.e., by the muscle strength of the
person riding it.
9.2 Pedelec
A Pedelec is an electrically powered assisted bicycle, or
EPAC (electrically power assisted cycle). When the assist
mode is switched on, the electric drive provides assistance
as long as you are pedalling. You can control the degree of
assistance, which is adjusted using various assist modes
 4.2 Pedelec/S-Pedelec: Original operating instructions –
System Page EN-10. The drive assistance is dependent on
the force and speed of your pedalling and the speed you
are travelling. Drive assistance stops as soon as you stop
pedalling and when the battery is discharged or if you
reach a speed of 25 km/h. Thus pedalling harder is required
if you want to travel faster than 25 km/h.
9.3 S-Pedelec
From a legal standpoint, the S-Pedelec is a Class L1e
moped. It may not travel at over 20 km/h using motor
assistance only. You can only reach speeds in excess of
this by combining the power of the motor with your own
physical strength. As soon as you reach close to 45 km/h,
the motor assistance switches o.
10. Frame marking
There are various markings on the bicycle frame which are
either stamped or glued on. You will nd out more about
this below. Please do not remove these markings.
10.1 Frame number
The frame number is a specic code
which is stamped into the frame.
This helps to identify the bicycle in
the event that it is stolen. It is best
to write down the frame number
immediately after buying the bicycle.
If you cannot nd the frame number,
ask your specialist workshop or take a
look at the brand website.
10.2 S-Pedelec: VIN
The Vehicle Identication Number
(VIN) allows every S-Pedelec to be uniquely identied. You
will nd the VIN on the right side of the seat tube in the
direction of travel, as well as on the manufacturer’s plate 
10.5 S-Pedelec: manufacturer's type plate Page EN-17 and the
EU Certicate of Conformity  4.4 S-Pedelec: EU Certificate
of Conformity Page EN-10.
Fig. 6 Vehicle identication number (VIN)
... AT2100001 ...
Fig. 5
Frame number
10.3 Bicycle (motorless)/S-Pedelec: serial and
product number
The serial number (S/N) and product number (P/N) identify
the bicycle (motorless)/S-Pedelec and provide information
on the production conditions and the components used.
S/N: 376784 082
P/N: 628568224
Fig. 3 S/N and P/N stickers
Fig. 7 Possible position of the labels
10.4 Pedelec: type plate
The type plate contains various information which
describes and identies the Pedelec.