2. SYSTEM OVERVIEW
Page 15 © 2005 DH Instruments, Inc.
2.1.3 GAS SUPPLY PANEL
The Gas Supply Panel is in the ADCS-601 Control. It is accessed by a door in the lower part
of the front of the Control Cabinet (see Figure 9).
The Gas Supply Panel is used to set and indicate gas pressure supplies
to various
ADCS-601 systems and components (see
Figure 10).
1. Regulator and gauge to set PG7601’s
AMH (automated mass handler) drive
air pressure.
2. Regulator and gauge to set drive
pressure for system pneumatically
actuated vavles.
3. Regulator and gauge to set FPG8601
piston-cylinder purge pressure supply
4. Regulator and gauge to set pressure
supply to the PG7601 system’s PPC3
pressure controller
5. Regulator and gauge to set pressure
supply to the FPG8601 system’s PPC3
pressure controller
6. Gas supply panel gauges and regulators
7. Drive air supply 5 micron filter trap
8. Drive air supply coalescing filter trap
*See Section 6.13 for regulator set values
Figure 10. Gas Supply Panel
To Next Page
Loading...