ADCS-601™ OPERATION AND MAINTENANCE MANUAL
© 2005 DH Instruments, Inc. Page 70
MAIN MENU
ITEM
SUB-MENU
ITEM
DESCRIPTION SEE
SECTION
PG PPC Adjust Run a routine to adjust the PG7601’s PPC3 pressure controller
relative to the PG7601.
6.10
FPG PPC Adjust Run a routine to adjust the FPG8601’s PPC3 pressure controller
Q-RPTs relative to the FPG8601.
6.10
PG Internal
Vacuum Zero
Run a routine to adjust the PG7601’s internal vacuum gauge
relative to its external CDG
6.9
Window Conventional Windows screen organization options. N/A
Help Information about ADCS Tools. N/A
4.3.3 ADCS MAIN TOOLBARS
The ADCS Main Toolbar is located across the top of the screen just under the Main Menu.
The ADCS Main Toolbar contents vary for different operations. The three possible toolbar
configurations and the operation of their buttons are summarized in
Table 14.
Manual operation toolbar
Running a manual test main toolbar (see Section
4.4.2.1)
Running a test definition toolbar (see Section
4.4.2.2)
Figure 34. ADCS Main Toolbar
Table 14. ADCS Main Toolbar buttons
BUTTON DESCRIPTION SEE
SECTION
Rotating DHI logo
or
ON button
Located at far left of the Toolbar. Shows a rotating DHI logo when the ADCS
Tools program is running normally. Stops rotating if the system software
has been paused or the computer has experienced a fatal fault.
Shows an ON button when the ADCS Tools program is NOT running. Press
the ON button to start ADCS Tools (see Section 3.8.1 before starting ADCS
Tools).
N/A
Run Test
Shortcut to the [R
un], [Run Test Definition] menu choice. When ADCS
Tools is running a test, this option is disabled.
4.4.2.1
Pause
Causes communications between ADCS Tools and system components to
pause, suspending most operation. To restart, when paused, press pause
again
When running a test, suspends test execution and pauses test timers.
4.4.2
Abort
Aborts sequential operations and functions such as changing measurement
modes or transitioning pressure standards.
This feature can be used to cut short certain operations such as the
FPG8601 Purge.
When running a test causts the <Abort Test> confirmation pop-up to appear.
N/A
To Next Page
Loading...