3. INSTALLATION
Page 33 © 2005 DH Instruments, Inc.
The bullet case screws open by turning the lid counterclockwise.
Table 6 details all items included with the PG7601 piston-cylinder module.
Table 6. PC-7100/7600-10, TC piston-cylinder module parts list
DESCRIPTION PART #
401562
1 ea. PC-7100/7600-10, TC piston-cylinder module 401418
1 ea. PVC bullet case 401642
Accessory kit including: 401243
1 ea. O-ring, Viton 2-222 101918
1 ea. O-ring, Viton 2-130 102380
1 ea. Piston insertion tool 122186
3.1.5 PG7601 MASS SET (MS-AMH-38)
The stability over time of PG7601 pressure measurements is a function of the stability of the
masses loaded on the piston. Precautions should be taken in handling the masses to
minimize influences that may change their mass. This includes always wearing protective
gloves when handling the masses to avoid contaminating them with body oils and
perspiration. Protective gloves are provided in the accessory kit of the PG7601 Platform.
The PG7601 mass set is shipped in (2) molded transit cases. The PG7601 masses should be
removed from their shipping cases and inventoried when actually setting up the PG7601 system.
To unpack: Do not unpack the masses until you are ready to install them on the PG7601
Platform (see Section
3.3.9.2). Wear protective gloves when handling the masses. Carefully
remove each mass from the transit case and take it out of its sealed plastic bag.
Table 7 details all items included with the MS-AMH-38 mass set.
Table 7. MS-AMH-38 mass set parts list
DESCRIPTION PART #
402219
1 ea. Molded transit case 402096
1 ea. Molded transit case 123949
38 kg mass set including: 402233
1 ea. Mass loading bell 402090
1 ea. Binary mass carrier 123855
1 ea. Mass lifting shaft/trim mass tray 402113
1 ea. 0.1 kg tubular mass 123850-01
1 ea. 0.2 kg tubular mass 123850-02
1 ea. 0.4 kg tubular mass 123850-03
1 ea. 0.8 kg tubular mass 123850-04
1 ea. 1.6 kg tubular mass 123850-05
1 ea. 3.2 kg tubular mass 123850-07
5 ea. 6.4 kg mass disc 123851
To Next Page
Loading...