DH Instruments ADCS-601 - Running a Standardization

To Next Page

To Previous Page

4. OPERATION

When the test is complete the Test Complete form displays. If automatic report

generation is enabled (see Section 4.4.2.2), the Report Editor creates a report.

4.4.6.2 RUNNING A STANDARDIZATION

When the ADCS-601 is connected to the model 3682 ADC, do not execute any

function on the 3682 that will cause it to vent pressure unless the ADCS-601 is

vented first. Causing pressure on the ADCS-601 TEST(+) port to vent when the

ADCS-601 is not vented may cause damage to the ADCS-601.

NOTE: The ADCS-601 is always vented before the model 3682 vents if the

procedures below are followed as instructed.

The model 3682 standardization procedure steps the operator through the model

3682 required sequence. This procedure cannot be fully automated due to

limitations in the model 3682 remote validation procedure.