MCQ-PRO RFID Reader — Installation and Tuning Manual Version 1.00
Page 10 of 89
1 Overview
DIALOC ID MCQ-Pro software is a Windows application that demonstrates all the features
of the new MCQ-Pro reader. It also permits you to easily setup the reader, test it and perform
RFID reading and writing operations.
This document provides a step-by-step guide for the following procedures:
Installing MCQ-Pro software on your PC
Configuring and using MCQ-Pro software
Managing your RFID devices and upgrading their firmware
Performing RFID reading operations
Sending specific tag commands
To Next Page
Loading...