MCQ-PRO RFID Reader — Installation and Tuning Manual Version 1.00
Page 34 of 89
Loading Radio Configuration from NVRAM
To load radio configuration from NVRAM:
1. Open “Favorite Devices” panel by clicking on the icon in the toolbar or by
choosing “Favorite Devices” in the “Device” menu.
2. Connect to the device to load the radio configuration by selecting it and clicking on
the icon .
3. In the drop down menu , select “ Load Configuration to NVRAM”.
Alternatively, you may as well right-click the device.
Restoring Radio Configuration to Default Factory Settings
To reset radio configuration to factory settings:
1. Open “Favorite Devices” panel by clicking on the icon in the toolbar or by
choosing “Favorite Devices” in the “Device” menu.
2. Connect to the device that you want to restore the radio configuration by selecting it
and clicking on the icon .
3. In the drop down menu , select “ Restore Factory Configuration”. Alternatively,
you may as well right-click the device.
5.1.7 Saving/Loading Device Configuration to/from Disk
To save device configuration to disk:
1. Open “Favorite Devices” panel by clicking on the icon in the toolbar or by
choosing “Favorite Devices” in the “Device” menu.
2. Connect to the device that you want to save the configuration by selecting it and
clicking on the icon .
3. In the drop down menu , select “ Save Configuration…”. Alternatively, you may
as well right-click the device.
To Next Page
Loading...