MCQ-PRO RFID Reader — Installation and Tuning Manual Version 1.00
Page 56 of 89
9 Tag Parameters and Commands
Tag parameters are specific to tag type and define:
Communication link characteristics between such tags and device
Options to apply when reading asynchronously (default read) such tags
Tag commands are special commands. For example, these commands may allow
reading/writing tags’ memory.
Many tag parameters and commands are specific to tag types, so please refer to manufacturer
specifications according to the tag types.
Before sending any command to tags, you should define default radio configuration and turn
the radio field on (see section 7.1.1 for more information)
9.1 C210
Open “C210” panel by choosing “C210” in the “Radio > Tag Parameters and Commands”
menu.
9.1.1 Parameters tab
Figure 46: C210 panel (Parameters tab)
Default Read
Sensitivity: defines reader sensitivity when attempting to detect a C210 in the RF field
(C210 is TTF). The higher the value, the higher the sensitivity.
Signal level threshold: a tag will be reported only if its signal level is greater or equal
to this threshold during asynchronous read. All tags will be reported if the threshold is
set to 0.
To Next Page
Loading...