Dialoc ID MCQ-PRO - Events

MCQ-PRO RFID Reader — Installation and Tuning Manual Version 1.00
Page 49 of 89
8.2.3 Events
A radio event happens during default read when an interesting action concerning tags has
occurred.
Before starting a default read, you must select radio events you need in
drop down menu of toolbar.
Each radio event is reported in its own panel during default read. See section 0
for more information.
There are several types of radio events that may occur during default read:
 “Tag Read” event occurs each time a tag frame is detected in radio field.
 “New Tag” event occurs the first time a tag is detected in radio field.
 “Tag In” and “Tag Out” events come in pair ( ) and occur respectively when
a tag enters or leaves the radio field.
 “No Read” event occurs if no tag has been read when reading stops (applicable
only if input triggered reading is enabled; see section 8.2.4 for more information).
 “Scan once completed” event occurs if “Scan Once” read mode is activated and when
the current scan is over.
You can configure the radio events settings on “Events” tab of “ Read Configuration”
panel.
If you enable “Tag In” or “Tag Out” event but not the other, both events will be
temporarily enabled during asynchronous reading.