12
Option 3 – Propagation Mode, Watering by Minute or Hour
1. This option is used to program the controller to operate the system in a cyclical
(propagation mode) manner from once every 1 minute up to every 12 hours.
Example: If a 5 minute watering frequency is selected, the controller will water
for the selected run time every 5 minutes from the entered start time until the
entered stop time every day until canceled by changing the program or turning off
irrigation.
NOTE: This mode is programmed differently. If you would like to proceed with the
controller in propagation mode, skip to section 15. Otherwise, continue on to Option 4.
Option 4 – Watering Once Every X Days (Cyclical Watering)
1. Push
to select Set Days .
2. Push and M will begin to flash then advance through days of the
week using
until 1 DAY appears flashing.
3. Push to select to water once every 1 to 30 days.
4. Push to confirm your settings.
To Next Page
Loading...
