DIG 710AP Series User Manual

15
12. SETTING WATERING RUN TIMES
This setting determines the length of time the 710AP controller will allow the
valve to remain open (run time is from 1 minute up to 5 hours and 59 minutes
in Irrigation Mode and from 5 seconds up to 59 minutes and 59 seconds in
Propagation Mode). For example, setting watering run time to 10 minutes on
certain days of the week will program the controller to turn the water on for 10
minutes on each of the days chosen and at every start time selected.
To set the watering run time :
1. Push to select Run Time . By default the Run Time is set to 5 min.
2. Push to select the hour and adjust using then push to set the
minutes.
3. Push to confirm your settings.
Push the button to proceed to the next step Seasonal Adjustment (Monthly
Budget) .

DIG 710AP Series Specifications

General

Brand	DIG
Model	710AP Series
Category	Controller
Language	English