13
To set the controller back to specific days mode:
1. Push to select Set Days . Previously selected days will be saved.
2. Push and then push until the days of the week can be seen at the top of
the LCD screen.
3. Push and advance through days of the week using and select each day
to water using .
4. Push to confirm your settings.
Push the button to proceed to the next step Start Time .
11. SETTING START TIMES
The 710AP controller can have up to five separate irrigation start times per
day set up for irrigation. If in propagation mode, only one start time is available
(along with a stop time).
1. Push to select Start Time . By default Start Time 1 is set to 6:00 AM.
You can view all start times by pushing .
2. Push to select the hour and adjust using then push to set
minutes.
3. Push to confirm your settings.
To Next Page
Loading...
Need help?
General
