To Next Page

To Previous Page

16. MANUAL WATERING

The manual mode allows the user to test the system and water for a specified

run time. The controller will automatically close the valve at the end of the defined

irrigation period. The originally programmed irrigation schedules will continue to

function at the times assigned. The sensor condition and OFF mode is disregarded in

this mode.

To start a manual run,

1. Push the button and the icon and icon appear. ON appears

momentarily and then the last watering run time is displayed with . The

controller will open the valve and in 3-5 seconds a count down of the remaining

irrigation run time appears, showing when the controller will close the valve. The

default run time is 5 minutes. Adjust to the desired manual run time length by

pushing .

2. Push the button to end manual run.

3. After 3-5 seconds the display will revert to the current time screen.

Questions and Answers:

Need help?

Do you have a question about the DIG 710AP Series and is the answer not in the manual?

DIG 710AP Series Specifications

General