Digi ConnectPort X2e ZB User Manual

Where to find more information
13
 User interfaces:
– The ConnectPort X2e ZB has a web user interface for both network configuration and
access to the log file for troubleshooting the initial connection to iDigi. For more
information on the web interface, see "Configuration" on page 27.
– Command-line interface differences: The ConnectPort X2e ZB allows access to the
Linux shell using SSH. This shell and common operations are described on page 68.
Access to the gateway is at the user level; the user is named python and the password is
dbps. Access to a command-line interface through Telnet is not supported for network
security reasons. Commands in the command-line interface for predecessor
ConnectPort X products are not supported. However, some of the ConnectPort X2
command-line interface commands have equivalents in the Remote Command Interface
(RCI).
 Firmware updates: Due to the complexity of the Linux-based system, standard
firmware updates cannot be used to downgrade a system.
 Logging: The ConnectPort X2e ZB supports continuous logging for troubleshooting.
The log files can be browsed from the web interface or pulled from the device filesystem
in the iDigi interface. They are stored in the Linux filesystem in the /WEB/logging
directory and persist across reboots and power cycles.
 Supported Python version: The ConnectPort X2e ZB uses Python interpreter version
2.7. Many predecessor ConnectPort X products use Python 2.4.
Any custom-compiled Python code must be recompiled for Python interpreter 2.7.
Custom Python modules are not 100% compatible with the ConnectPort X2e ZB.
Therefore, porting may be required in addition to recompiling.
Where to find more information
In addition to this guide, find additional product and feature information in the these documents.
These documents are available from Digi’s Support page http://www.digi.com/support/
unless
otherwise noted.
 XBee/XBee-PRO ZB SMT RF Modules Product Manual (90000976), for more
information about features and operation of the XBee RF module mounted inside the
gateway.
 ConnectPort X2e ZB programming content within Digi ESP for Python
 The Wiki page for additional programming content for ConnectPort X2e products:
http://www.digi.com/wiki/developer/index.php/ConnectPort_X2e
 The Programming section lists several references and tutorials for users new to a Linux-
based filesystem and the ash command shell.iDigi Dia library documentation
 iDigi User’s Guide
 iDigi Web Services Programming Guide
 iDigi tutorials and other documents available on iDigi.com

Digi ConnectPort X2e ZB Specifications

General

Brand	Digi
Model	ConnectPort X2e ZB
Category	Network Router
Language	English