Digi SM-500MK4 DP - 4.4 User Spec Setup Procedure

SM500MK4 Service Manual
17
4.4 User Spec Setup Procedure
To Change the setting of the User SPEC, if there is some SPEC need to alter.
KEY TO PRESS OPERATION
In the Weighing Mode, press
then turn On the Span Switch.
-- Go to Z mode.
KEY TO PRESS OPERATION
+ [1][4][1]
-- Go to User Specification Mode
-- To change the selection for the Spec, press the
Number of the selection
-- Press the key to Save go to next Spec
-- Press ‘-‘ key to go back to previous Spec
-- Press ‘PLU’ to save and exit
-- Press ‘Tare’ to exit without saving
KEY TO PRESS OPERATION
[0] To [2][0]
-- Select data. (Refers to Customer Spec setting)
OR
&
-- To choose scale type.
Then
-- To set. (Save data and increase SPEC No)
KEY TO PRESS OPERATION
-- Increase the SPEC number without saving data of
the previous SPEC number.
All manuals and user guides at all-guides.com