2
ii) Safety Information
The operator of the equipment shall comply with the safety and warning indications and procedures outlined in
this document. Teraoka Weigh-System Pte Ltd assumes no responsibility or liability for failure to comply with
these requirements.
• To avoid electric shock, use only the supplied power cords and ensure product is connected to a
properly grounded supply.
• For continued protection against fire hazard replace only with fuse of same rating and type.
• Ensure product is placed on a firm and level surface before operation.
• Avoid overloading the product beyond its rated maximum capacity
• Ensure commodity to be weighed is loaded centrally on the platter.
- Avoid placing commodity on corners or edges.
• Care shall be taken during the following operations
o Receipt paper tearing – to prevent injuries from cutting from paper cutter
o Changing of labels and receipt paper - to prevent injuries from cutting from paper cutter and
movable printer mechanism.
• Trained and qualified personnel shall only carry out repair and servicing of product.
Disclaimer:
Specifications are subject to change without notice. All dimensions shown are approximate. Please be aware
that Teraoka has indicated that its hardware and software used in the product may require additional updates in
the future as our product is continually under development. The need for such updates most likely applies to the
Printer software.
CAUTIONS:
1. FOR PLUGGABLE EQUIPMENT, THAT THE SOCKET-OUTLET SHALL BE INSTALLED NEAR THE
EQUIPMENT AND SHALL BE EASILY ACCESSIBLE.
2. FOR CONTINUED PROTECTION AGAINST RISK OF FIRE, REPLACE ONLY WITH SAME TYPE
AND RATING OF FUSE.
3. DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. REPLACE ONLY WITH
THE SAME OR EQUIVALENT TYPE THAT RECOMMENDED. DISPOSE OF USED BATTERY
ACCORDINGS TO THE MANUFACTURER’S INSTRUCTIONS.
To Next Page
Loading...
Need help?
General
