UTM-00339 | Rev 19
Page 138 of 253
DetNet South Africa Copyright © 2021
This screen will list the detonators that were found to have an error status during the test. (A bad status indicates
the detonator may have a bad fuse or another internal problem).
1. Main Menu
• Press to select View Design
2. View Design Menu
• Press SoftKey to select List Bad Status Detonators
3. List Bad Status
• The List Bad Status screen will be displayed
• Use SoftKeys to sort/filter or display other information as required.
This List does NOT include untagged detonators.
Failures may be the result of cable damage, connector or other problems.
A bad status detonator must be replaced even if subsequent test results indicate good.
To Next Page
Loading...