UTM-00339 | Rev 19
Page 195 of 253
DetNet South Africa Copyright © 2021
• Press both FIRE-buttons (SoftKeys) on the CE4 Tagger
simultaneously to fire
• The Commander will count down from 5 seconds to allow
for the synchronisation of all Bench Commanders and will
blast at 0 seconds
• BLASTING WILL TAKE PLACE
• Blast Command sent message will be displayed
29. Main Menu
• Press SoftKey to select Prepare for Blast.
30. Prepare for Blast
• Press SoftKey to select Program Detonators.
The following shows how to setup an un-synchronized blast of more than one Bench
Commanders from one Base Commander.
This is not recommended unless the benches are far from each other and it does not
matter which one will fire first.
Unsynchronized blast should be conducted when the RF signal strength is 60% and above.
The maximum time difference during an unsynchronized blast between bench
commanders is 15 seconds.
To Next Page
Loading...