UTM-00339 | Rev 19
Page 196 of 253
DetNet South Africa Copyright © 2021
31. Program Detonators
• Detonators will be programmed
• Press or button to return to Prepare for Blast Menu.
32. Prepare for Blast
• Press button to select Arm.
33. Arm
• Press button to select Remote Blast
ARM AND FIRE COMMANDS FOR DETONATORS WILL NOT INITIALLY BE KNOWN TO THE DIGISHOT
®
PLUS
4G COMMANDER AT POWER ON. THESE COMMANDS ARE ONLY AVAILABLE FROM THE BLASTING (RED)
BLASTCARD AND WILL BE ISSUED TO THE COMMANDER WHEN NECESSARY, EITHER DIRECTLY FROM THE
RED BLASTCARD (IN CASE OF A LOCAL BLAST) OR REMOTELY FROM THE BASE DIGISHOT
®
PLUS 4G
COMMANDER. ARM AND FIRE BLASTING COMMANDS WILL BE ERASED FROM THE COMMANDER MEMORY
AFTER USE.
34. Remote Blast
• Press SoftKey to initialise RF communication
• User may change RF settings by selecting corresponding numbers. Refer to 15.3
for detailed RF settings procedure.
35. Remote Blast
• User will be prompted to Scan Key
• Scan the Yellow BlastCard at the back of the DigiShot
®
Plus 4G
Commander
To Next Page
Loading...