UTM-00339 | Rev 19
Page 39 of 253
DetNet South Africa Copyright © 2021
1. Press the ON key.
2. The splash screen will display for approximately 1.5 seconds during the CE4 Tagger
boot sequence.
3. The system name will be displayed.
4. The software release and hardware version number will be displayed similar to
example shown.
ONLY TRAINED USERS SHALL BE ALLOWED TO USE THIS EQUIPMENT.
5. Warning will be displayed to indicate that the Tagger is due for service
(If applicable)
6. Press the SoftKey to acknowledge and continue.
7. Warning will be displayed indicating that Tagger must have a unique number which
the user must acknowledge before proceeding
8. Press the SoftKey to acknowledge and continue.
9. Disclaimer will be displayed which the user must acknowledge before proceeding.
10. Press the SoftKey to acknowledge the Disclaimer.
The charging screen will only be displayed when the CE4 Tagger is
connected to a USB, Wireless charger, external battery pack, or charging
source. Pressing ESCAPE returns the user to the original screen and
prevents this screen being shown again until the next power-on
sequence.
Release 45232G
Hardware ver.4
To Next Page
Loading...