UTM-00339 | Rev 19
Page 85 of 253
DetNet South Africa Copyright © 2021
The Advanced Mode option is more complex than the Basic Mode as it allows for multi-primed holes and the user
will need to control several parameters within this mode. To define a hole configuration the “Site Setup” screen will
need to be accessed. The Advanced (A) Tagging option also allows the user to tag detonators using Detonator
Label methods as follows:
• Method 1: {NNNNN} {N}, a hole number and det number is assigned
• Method 2: {NNN} {NNN} {N} a group number depicted as Row number, hole number and det number is
used.
• Method 3: {AA} {NNN} {N}, a user configurable 2 letter group number, hole number and det number is
assigned.
• Method 4: {A} {NNNNN} {N}, a user configurable single letter group number, hole number and det number
is assigned.
With the Planned (P) tagging option, both the location and a delay must be written into the detonator.
The data written into the detonator is taken from a plan downloaded into the CE4 Tagger via ViewShot 3D.
When exporting the design from ViewShot 3D as “Send Plan Locations Only (4G Only)”, only the connection
sequence and blasthole numbers will be exported to the tagger.
Manual locations can also be deployed separately from delays by using Advanced mode with “Assign Location”
setting checked. This feature can be used when the delays are not yet known.
Delays can be deployed to the tagged detonators later in Planned mode, using the available plan based on location
matching.
To Next Page
Loading...