Keys "<" and ">" to switch Direct sound to the center and Effect to the center.
Turning knob "usic volume / edit (press) "to set.
Operating method 2: Operation from the interface software to set up
9.4 Center PEQ settings
The PEQ qty: 3
Type: parametric equalization filter (can be set to low / treble tone filter) and graphic equalizer.
Frequency range: 20hz ~ 20khz
Gain Range:-15db ~ +12 db, step 0.1db
Bandwidth range: 0.011 to 3.595
Operation method1: (Only can set EQ gain on the panel)Press the buttons "Mic Mode" on the panel continuously
into the CENT PEQ, as shown below:
Keys "<" and ">" to select the needing PEQ
Turning knob "usic volume / edit (press) "to set gain
.
Operating method 2: Operation from the interface software to set up
9.5 High-cut, low-cut settings
Low-cut range: OFF, 20Hz ~ 300Hz, stepping 5Hz
High-cut range: 2.5kHz ~ 20kHz, OFF, stepping 0.5khz
Operating method : Operation from the interface software to set up
18
CENT PEQ 101Hz1
0.0
+ 6
- 6
Panel
Panel
Display
Panel
To Next Page
Loading...
