12 、Turn-On to load the selected program.
22
11.3 program deleted (computer software interface features)
11.4 program data is saved to the computer (computer software interface features)
11.5 program import the data from the computer to the processor (computer software interface features)
Connect the Processor unit to the computer ,open the software, set the program in"eboot effect"rom "evice setting"
(Program 1-4; Last program status before turn off).
The default program will be one of 1-4 whether or not making any parameter
adjustment before reboot. This feature is to prevent extra work loaded applied to the
Musical Technicians.
Default program remain the same to prevent sudden power failure.
Programs(memories)
1 4－
Last program
13 Volume, Maximum gain limit functions
14 volume fader function
Set through the online software interface with the computer: "Device Settings"
Maximum volume of the music: Mute,-30db ~ 0db, Stepping: 0.5db
Maximum volume of the microphone: Mute,-25db ~ +6 db, Stepping: 0.5db
Maximum volume of effect: mute,-30db ~ 0db, Stepping: 0.5db
Maximum volume of center: mute,-30db to 0db stepper: 0.5db
Maximum volume of subwoofer: Mute,-30db ~ 0db, Stepping: 0.5db
The maximum gain of music equalizer : +6.0 db to +12.0 db, Stepping: 0.1db
Volume limit feature: To protect and prevent damaging speakers and amplifier in a certain range.
To avoid setting too high volume destroyed the sound field. Example: When the microphone parameter is set to-10db,
then the upper limit value of microphone volume is-10db, when using the microphone volume knob or the remote control
to adjust the microphone volume, maximum output volume is -10db.
Set this function under "Device Settings" in the software provided.
If the Switching Speed of its parameters set to fade during power On/off, Recall program, conversion mode,
the signal line, the signal is from small to large incremental increase; If the parameter set to "immediately",
the signal is changed over directly without fading process.
、
、
" "
To Next Page
Loading...