DigiTech iPB-10 User Manual

18
A-E Footswitches
Use these footswitches to turn the assigned eect pedals on
and o. When a pedal is acve, it’s footswitch LED will light.
Stomp Loop
This footswitch enables and disables the
mono stompbox eects loop. The LED
lights when the stomp loop is enabled.
Amp Loop
This footswitch enables and disables the
amp loop. The LED lights when the amp
loop is enabled.
Expression Pedal
This pedal provides
real-me control of
Volume, Wah, or any
other assigned eect
parameter. Rock the
pedal forward and
press rmly to toggle
between controlling
the Wah and the other
assigned parameter.
iPB-10 Top PaneliPB-10 Top Panel
NOTE: Status messages will be displayed if the AMP or STOMP footswitches are pressed and the Amp or Stomp Loop
modules are not used in the current preset Tone (unavailable), or if nothing is connected to these jacks (not connected).
NOTE: When using the
Expression Pedal, the Wah
will only be controlled if it
exists in the eects chain.

DigiTech iPB-10 Specifications

General

Brand	DigiTech
Model	iPB-10
Category	Music Pedal
Language	English