20
Amp Loop
These 1/4” send and return jacks allow you to connect an
external preamp or amplier and use the tone from these
components instead of the internal ampliers of the iPB-10.
Stomp Loop
These 1/4” send and return jacks
allow you to insert an external
stompbox eect pedal (or chain
of eects) into the iPB-10 signal
path.
Amp Loop Ground Lift Switch
This switch can be enabled to help prevent unwanted
hum or buzz caused by ground loops between the iPB-10
and an externally connected amplier or preamp.
NOTE: Status messages will be displayed if the AMP or STOMP footswitches are pressed and the Amp or Stomp Loop
modules are not used in the current preset Tone (unavailable), or if nothing is connected to these jacks (not connected).
To Next Page
Loading...
Need help?
General
