Digno Keitai - Specifications; Materials

95
Appendix
DIGNO
®
ケータイ
Specifications
DIGNO
®
ケータイ(Keitai)
Handset specifications are as follows.
・Times in the table vary with location, status, settings, etc.
・Display employs precision technology; however, some pixels
may remain on/off.
Item Description
Weight
Handset: Approx. 105 g
Battery installed: Approx. 130 g
Continuous
Talk Time
1
4G (LET: FDD-LET network): Approx. 530
minutes
3G: Approx. 780 minutes
GSM: Approx. 360 minutes
Continuous
Standby Time
2
4G (LET: FDD-LET network): Approx. 530
hours
3G: Approx. 680 hours
GSM: Approx. 580 hours
(handset closed)
Charging
Time (powered
off)
AC Charger: Approx. 120 minutes
Dimensions (W
× H × D)
Approx. 51 × 114 × 17.9 mm
(handset closed, without protruding parts)
Maximum
Output
4G (LET: FDD-LET network)：0.2 W
3G：0.25 W
GSM (900 MHz)：2 W
GSM (1800 MHz,1900 MHz)：1 W
1 Average measured with handset fully charged, in strong
signal conditions at rest.
2 Average measured with handset fully charged, without
calls or operations, in strong signal conditions at rest, and
with data communication and Urgent News disabled. May
vary with battery strength, ambient temperature, settings,
etc.
Battery (KYBAH1)
Item Description
Voltage 3.8 V
Battery Lithium-ion
Capacity 1500 mAh
Dimensions (W
× H × D)
Approx. 36.0 × 5.6 × 57.1 mm (without
protruding parts)
Materials
DIGNO
®
ケータイ(Keitai)
Where used Material/Finishing
Outer Case
(LCD Case)
PA + GF resin/UV cured acrylic coating
Outer Case
(Key Case)
PC + GF resin/UV cured acrylic coating
Outer Case
(Hinge Cover),
Back Cover
PC resin/UV cured acrylic coating
Outer Case
(LCD Rear
Plate)
PMMA resin/in-molding
Infrared Port
Window,
Window
Panel (Main),
Camera Plate
PMMA resin/chemical hardening
Multi
Selector,
Center Key,
Mail Key,
Browser
Key, TV Key,
Camera Key,
Start Key,
Clear/Back
Key, Power/
End Key,
Dial Keys,
Key, Key,
Notification
Key, App Key,
History Key
PMMA resin
Key Sheet PET resin/UV cured resin
Cushion
(Under 10KEY)
UV cured resin
Side Key PC resin/UV cured acrylic coating
External
Device Port
Cover
PC resin + TPE resin/UV cured acrylic
coating
Charging
Terminals
Phosphor bronze/gold plating (base:
nickel)
Battery (KYBAH1)
Where used Material/Finishing
Outer Casing PC resin
Sticker PET
Terminals Gold plating