41
© 2009 Directed Electronics. All rights reserved.
Choose. Within 10 seconds, press and release 4.
the Valet/Program switch the number of times
corresponding to the feature number you want to
program and then press and hold the switch.
(See Feature Menus. After a second, the LED will
flash to indicate which feature you have accessed.
For example, in Menu 3, a group of 5 flashes indi-
cates access to the activation pulse setting (Feature
3-5). The siren will also chirp 5 times.
Transmit. The transmitter is used to select the desired 5.
setting. Pressing
changes the feature to the LED On
setting (or flashes once for features with more than 2
settings). The siren honks once. Pressing
chang-
es the setting to the LED OFF setting (or flashes two
or more times for features with more than 2 settings) .
Release, the Valet/program switch. 6.
You can advance from feature to feature by pressing and releasing the Valet/
Program switch the number of times necessary to get from the feature you just
programmed to the feature you wish to access.
For example, in Menu 1, if you just programmed Feature 1-2 and you next want
to program Feature 1-3 to Off, release the Valet/Program switch. Press and
release it once to advance from Feature 1-2 to Feature 1-3. Then press it once
more and hold it. The LED will flash in groups of 3 and the siren chirps to confirm
that you have accessed Feature 1-3.
The learn routine is exited when:
The door is closed.•
The ignition is turned on.•
The Valet/Program switch is pressed too many times.•
More than 15 seconds elapses between programming steps.•
•
Once long siren chirp indicates that the Learn routine has been exited.
To Next Page
Loading...
Need help?
General
