80
Operating Other Devices
Chapter 10
Note: SAT Auto-Tune is enabled by default; however, the channel must be set (see
Setting SAT Auto-Tune Channel).
1 Press and hold the SAT mode button for three seconds until all four mode buttons are lit.
2 Press the STAR (*) button on the remote control.
3 Press VOLUME UP to enable SAT Auto-Tune or VOLUME DOWN to disable the feature.
4 Press the POUND (#) button on the remote control.
Removing the SAT Auto-Tune Channel
1 Press and hold the TV mode button for several seconds until it stays lit.
2 Press the STAR (*) button on the remote control.
3 Enter the digits 00 or 000 using the NUMBER PAD.
4 Press the POUND (#) button on the remote control.
Setting SAT Auto-Tune for DVD/VCR
1 Make sure your remote control operates your DVD/VCR.
2 Press and hold DVD Mode button for three seconds until all four Mode buttons are lit.
3 Press the STAR (*) button on the remote control.
4 Enter the channel used for viewing (up to three digits in range of 002 to 125), for example
channel “003” or “004.”
5 Press the POUND (#) button on the remote control.
To Next Page
Loading...
