88
Operating Other Devices
Chapter 10
Remote Is Not Recognized
The remote control may not be immediately recognized by your receiver.
1 Press and hold ZERO (0) to open the System Wizard.
2 The System Wizard screen says the receiver does not recognized the remote.
3 To use the remote with the receiver, select Continue. Information transfers to enable
remote use.
4 The setup is complete. Select Continue to watch TV.
Adjust Remote Configuration
You may see a screen asking you to adjust the physical configuration of the remote
control.
1 The System Wizard screen describes if the remote is configured to IR or UHF.
2 To keep the current configuration, select Continue.
OR
Select Reconfigure. Settings will take a few minutes to transfer. Do not move the remote
or the receiver during this process.
3 Select the desired remote configuration on the screen and adjust the remote to match the
screen configuration.
4 A message appears indicating the conflict is resolved. Select Continue to watch TV.
System Wizard screen displays
and says the receiver does not
recognize the remote
Select Continue
Continue
Press and hold zero
to open the System
Wizard screen
4
Setup is complete
Select the remote’s
configuration and adjust
the remote to match the
picture on the screen.
Select Continue.
Select
Reconfigure
Reconfigure
UHF
IR
or
Continue
A message will
appear on the
screen that the
conflict is resolved.
4
System Wizard screen displays
and indicates if the remote is
configured to IR or UHF.
To keep the current
configuration,
select Continue
Continue
To Next Page
Loading...
