10
Charging
The capacity of the FREEDOM’s Li-Ion battery is about 20 hours, depening on ambient temperature
and extent of use. Charging of the FREEEDOM is quite simple. Unscrew the connector lid (between
the buttons) with a coin. Attach the charging connector and connect it to your personal computer via
USB or to a wall socket using the standard electrical plug. When battery is charged, the “C” symbol
appears. If the battery is fully the “F” symbol appears.
Charging time is four hours.
Activation
Press BOTH KEYS for five seconds. The FREEDOM boots and you can check the hardware and
software version during this time. If you want to read the splash screen with the serial number and
license, keep one of the buttons pressed. After booting, the FREEDOM switches to surface mode.
After descending to a 1.5 meters, the FREEDOM is activated automatically. In the mode in which it is
activated depends on the default mode setting.
Control
Buttons
The Freedom is controlled with two buttons; depending on the configuration, tilting and
clicking are used for editing data. Irrespective of the orientation (right or left hand), the top
button is labeled K1 and K2 is at the base.
Each button can be pressed briefly (at least 250ms) or for a longer time (press and hold at
least 2.5s).
List of handling and labeling as used in the following description
To Next Page
Loading...