35
The safety stop is interrupted if the diver falls below a depth of six meters. After returning above this
depth, the safety-stop countdown starts again from the beginning. When the diver completes a
safety stop and then falls below 10 meters again, then it is necessary to make a safety stop from the
beginning.
During a safety stop it is possible to play games (in fixed position preventing unwanted ascent or
deep descent). After termination of the safety stop, the free ascent arrow is displayed again and the
diver can end the dive.
End dive
When you terminate a dive, you can end the dive on the computer manually or wait for automatic
termination. For manually ending a dive, go to the Open circuit menu and select end dive. This is
possible only on the surface. Automatic end dive occurs after ascending above a depth of 0.5 m. If
you resume diving with 10 minutes after the last ascend, it will be logged as a one dive. If you
actually finish diving at that moment, the dive time will be logged until the moment of exceeding 0.5
m.
Decompression dives
WARNING: Decompression dives must be preceded by proper planning. Make sure that you have a
sufficient gas supply for your dive. Plan the dive, dive the plan! Do not exceed your personal
qualification limits!
The start of a decompression dive is the same as that of a No-decompression dives. At the moment
of termination of the no-decompression limit, the upper right box changes from NO DECO to
ASCENT. Ascent shows the ascent time from the current depth in minutes including deep and
decompression stops.
In the upper left box, the depth of the first decompression stop is displayed. The time until the stop is
shown below in minutes and seconds.
To Next Page
Loading...