46
Gauge mode
Gauge mode serves as a high-precision depth gauge for those who do not want to use
decompression data. Gauge mode is indicated by a red frame. The following functions are displayed:
Stopwatch, current depth, dive time in seconds, maximum depth, temperature, battery status.
After each dive, the diver has residual nitrogen in his/her tissues. For this reason, diving without
proper knowledge about your previous saturation is not safe. If you want to use Gauge mode after
a scuba dive, make sure that you can use dive tables or decompression planning software for your
next exposure. Divesoft is not responsible for any decompression problems caused by poor
planning and using Gauge mode.
Activating Gauge mode
Go to Surface mode main menu> Gauge mode
If you have Gauge mode set as your priority mode, it starts automatically after you enter the water
and dive below 1.5 m.
Stopwatch
The stopwatch is activated with KEY 2, stopped with KEY 2 again, and reset with KEY 2 LONG.
End dive and deactivation
The dive is terminated at the moment of exceeding a depth of 1.2 m.
The dive mode is automatically deactivated after 10 minutes following the last dive. For manual
deactivation, press BOTH KEYS and select End dive.
To Next Page
Loading...