20
Plan order determines whether depth issues in the plan are arranged from the top down or reverse.
“normal” bottom time and the first stop are below
“reverse” bottom time and the first stop are above
Key press delay
Main menu > Setup > Preferences > User interface > Key press delay
You can choose how long you must press the button for a given action. The default setting is 250ms
for short press. A press that is too short could be activated unintentionally and a press that is too
long is not very practical when you must wait for navigation in the menu.
Long press is 2.5 seconds and cannot be changed.
Editor navigation
Main menu > Setup > Preferences > User interface > Editor navigation
This menu determines if you will control the entering of values by tilting or tapping.
Gas shortcuts
The second way is with a key shortcut. When you press KEY 1 LONG, the computer switches to the
next gas in your list. You can scroll in the list this way cyclically. This is the quick and easy way to
change your gas. In light of the fact that there is a certain risk of unintentional switching of gases
during a dive, this option is adjustable in the (Main menu > Setup > Preferences > User interface >
Gas shortcuts) in firmware version 1.5. Key shortcuts are activated by default.
Salinity
Main menu > Setup > Preferences > Salinity
Although you will change this item more often, it is a good idea to set the predicted more frequent
salinity mode: Salt water / Fresh water
NOTE: The salinity setting doesn't affect decompression procedure. It affects just depth measuring
and indirectly the depth of decompression stop (rounded to 3m / 10ft) due to the different water
density.
Default mode
Main menu > Setup > Preferences > Default mode
You can choose the mode that you prefer. This means that if you dive below the activating depth (1.5
m), the chosen default mode will be activated. So select the mode in which you dive most often and
in which you are most likely to dive. Of course, you can always change it.
Factory defaults
Main menu > Setup > Factory defaults
If you are not sure about custom settings, set all settings to default.
To Next Page
Loading...