EasyManua.ls Logo

Divesoft Freedom - Page 26

Divesoft Freedom
51 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
26
Ceiling – alarm triggered by exceeding decompression ceeling
Deco stop miss – alarm triggered by missing a decompression stop
CNS – alarm triggered by achievement 75% and 100% CNS clock
pO2 – alarm triggered by exceeding the safe limit of oxygen partial pressure (1.6 bars)
RATES
Descent rate – alarm triggered by exceeding the descent rate
Ascent rate – alarm triggered by exceeding the descent rate
Low battery alarm - In firmware version 1.5, a low-battery alarm can be set (Main menu > Setup >
Alarms > Alarm sources > Low battery). The values can be set in the range of 0 to 40% (this pertains
to the percentage of the fully charged battery), whereas 0 means a triggered alarm. If you set the
value lower than 10%, the alarm alerting you to the battery’s critical status will be triggered
automatically when reaching the 10% charge level of the battery.
NOTIFICATIONS

Table of Contents