Page 9
LOADING
LOADING CHANGE TUBES
MDB AND MICROMECH UNITS
Open the service door.
Load the coin mechanism with coins to the desired level by inserting coins in the loading slots on the coin tube front.
Minimum coin tube levels are:
6-8 nickels
7-8 dimes
5-6 quarters
NOTE: A low coin level in the coin tubes will interfere with operation of the bill validator.
(For additional information about coin mechanism refer to manufacturer's instructions.)
CASHFLOW 560 UNITS
Open service door.
Load coin mechanism with coins to desired level by inserting coins in the loading slots on the coin tube front.
(For additional information about coin mechanism refer to manufacturer's instructions.)
LOADING PRODUCT
Proper product loading and product sizing to spacer/gate are very important in ensuring problem free vending. Pay
close attention to the product's center of gravity. Taller products, such as the 20 oz. Pepsi and Coke products and
the Arizona Iced Tea in the 16.9 oz. can, cannot be vended from trays A or B. Regional products are sometimes
bottled and/or canned in unique shapes and sizes. It is strongly recommended these products be tested for problem
free vending before large quantities are purchased.
Note: Loading should be done as quickly as possible to minimize product/cabinet exposure to warmth and
humidity.
Open the service door then open the product compartment glass door.
After loading is finished check the price tags to ensure they correspond to existing products. Pricing labels are
located in the service bag shipped with every vender.
Close the product compartment glass door.
Close the service door and lock. Closing the service door will place the machine in service and start the
refrigeration cycle.
To Next Page
Loading...
