Page 50
GENERAL MAINTENANCE
The most important facets of proper care and maintenance of your machine are the electrical power supplied to it,
leveling, and cleanliness of the machine.
POWER
• This machine must be connected to a dedicated 120 VAC, 15 Amp circuit (U.S. and Canada) or
22OVAC, 6 Amp circuit (International) for optimum performance.
CAUTION: Remove power to the AC distributor box when any electrical components are connected /
disconnected for testing or replacement.
CLEANING
• The Condensers and condenser fans on the Tecumseh Roll-Up unit must be checked and cleaned
using a vacuum or brush to clear any dust accumulation.
• The display glass area should be cleaned, inside and out, with glass or non-abrasive all purpose
cleaner, using paper towels.
• Trays and tray inserts should be cleaned periodically using warm water and any mild general
purpose, non-abrasive cleaner. Care should be taken to ensure water does not enter the solenoids.
Do Not use solvents or abrasive materials to clean any portion of the tray.
• Product delivery bin should be cleaned periodically using warm water and any mild general purpose,
non-abrasive cleaner.
• Gasket around product door should be wiped down using warm water, any mild general purpose,
non-abrasive cleaner and a soft towel. Never lubricate gasket and always check for cracking or
deformities which may cause leaks. Replace if necessary.
• The coin sensor in the coin mechanism and the bill path in the bill validator should be checked and
cleaned periodically. Refer to manufacturer's instructions for guidance.
Cleaning of product delivery bin and cleaning the condenser area all require removal of the product delivery bin.
To remove:
• Open service door.
• Open product door.
• Pull bin straight out until clear of the machine and set aside.
When reinstalling make sure that product delivery bin is pushed all the way back before closing product and service
doors.
To Next Page
Loading...
