Page 5
INSTALLATION & SET-UP
The Glass Front Beverage Maximum Display Can and Bottle vender is designed utilizing the latest technology.
RECEIVING INSPECTION
DO NOT STORE THE VENDER OUTSIDE.
Upon receipt, inspect the vender for any shipping damage. If there is any damage have the driver note the damage
on the bill of lading and notify Dixie-Narco. Although the terms of sale are FOB shipping point, which require the
consignee to originate shipping damage claims, Dixie-Narco will gladly help if you must file a claim.
UNPACKING THE VENDERS
Remove the stretch wrap fiberboard edge protectors and corrugated front protector from the outside of the vender.
Once the vender is unpacked, check the recovery unit for any additional parts, price/product labels,
service/operation manual, or other information concerning factory equipped accessories.
ELECTRIC POWER NEEDED
Refer to the cabinet serial number plate to determine the proper voltage and frequency the machine requires
(domestically this requirement is 115 Volts, 60 Hertz). Domestic venders will operate properly at +/-10% of the
specified voltage. For domestic models this is between 103 volts and 127 volts. The cabinet serial plate also
indicates the Amperage of the vender. Single phase, alternating current is required. The vender must be plugged in
its own properly rated circuit with its own circuit protection (fuse/circuit breaker).
DO NOT USE AN EXTENSION CORD.
GROUND THE VENDER
The vender is equipped with a three wire power supply cord and MUST be plugged in a properly grounded
outlet.
DO NOT REMOVE THE GROUND PIN OR IN ANY WAY BYPASS THE GROUNDING OF THE VENDER.
If the outlet will not accept the power cord plug, contact an electrician to install a proper AC outlet.
WARNING: Failure to comply with these instructions may subject the user to the risk of injury or
electrical shock which can be serious or fatal.
To Next Page
Loading...
