Dixie Narco 2145 - SERVICE MODE; CLEAR TOTALS; ENABLE ITEM

Page 13
SERVICE MODE
Enter SERVICE MODE by opening the service door and pressing the Mode Selection button once. The display will
read “SERVICE MODE”.
CASH BOX
Shows the amount diverted to the cash box from the coin mech since the last CLEAR TOTALS or MASTER RESET.
To view the amount diverted to the cash box press the letter “B” on the keypad and the display will read “CASH BOX
$###.##". Press the "CLR" key to return to "SERVICE MODE".
SALES
Shows the total sales since the last CLEAR TOTALS or MASTER RESET.
To view the total sales press the letter “C” on the keypad and the display will read “SALES $###.##".
Press the "CLR" key to return to "SERVICE MODE".
SET COOL TIME
Allows the service technician to vary the time duration of the cool down period from 0 to 255 minutes. If no time is
entered here, and the SET COOL DOWN feature is started, the time duration of the cool down period will be 240
minutes (4 hours).
To set the cool down time press the letter "D" on the keypad and the display will read "SET COOL TIME". Press the
"*" key and the display will read "COOL T". Use the keypad to enter the duration of the cool down period that you
wish to use. Press the "*" key to enter the cool down time displayed. Press the "CLR" key to return to "SERVICE
MODE".
SET COOL DOWN
Allows the service technician to start the cool down period for each selection that is warm after restocking. This
feature may be set on an individual item, a complete tray, or the entire machine. Once set, the cool down period
duration is the time entered by the service technician in SET COOL TIME, or the default time of 240 minutes if no
time was entered. Press the letter “E” on the keypad and the display will read “SET COOL DOWN”. Press the “*”
key and the display will read “ITEM”. There are now three choices:
1. Pressing the “*” key will place the entire machine in cool down.
2. Pressing a tray selection followed by “*” will place that tray in cool down. (For example, pressing
“A*” will place the “A” tray in cool down.
3. Pressing an item selection will place just that item in cool down. (For example, pressing “A1” will
place that selection only in cool down.
Press the "CLR" key to return to "SERVICE MODE".
CLEAR TOTALS
Allows the service technician to clear totals in CASH BOX, SALES, NUMBER SOLD, DOOR OPENINGS, and
POWER OUTAGES. Press the letter “F” on the keypad and the display will read “CLEAR TOTALS * = Y”. Press
the “*” key, the totals are cleared and the display returns to “SERVICE MODE”.
NUMBER SOLD
Shows the total number of items sold since the last CLEAR TOTALS or MASTER RESET. Press the number “1” on
the keypad and the display will read “NUMBER SOLD ###”. Press the "CLR" key to return to '"SERVICE MODE".
ENABLE ITEM
Allows an individual selection, a complete tray, or the entire machine to be enabled or disabled. Press the number
"2" on the keypad and the display will read "ENABLE ITEM". Press the "*" key and the display will read "ITEM".
There are now three choices:
1. Pressing the "*" key will toggle between enable and disable for the entire machine, the display will
show the current state.
2. Pressing a tray selection followed by "*" will show the current state of that tray, for example, pressing
"A*" will show the current state for the A tray, pressing '"A*" again will toggle the state.
3. Pressing an item selection will show the current state of that item, for example, pressing "A1" will
show the current state of that item, pressing "A1" again will toggle the state.