Page 14
Press the "CLR" key to return to "SERVICE MODE".
ESCROW
Allows a bill to be returned if the change return lever is pressed before a selection is made.
Press the number "4" on the keypad and the display will read "ESCROW Y" or "ESCROW N", depending on the
current state. Pressing the "*" key will toggle the state. This feature only affects those machines with a bill validator
installed. Press the "CLR " key to return to "SERVICE MODE".
FORCE
Allows the change return lever to be inhibited until after the lowest vend price is made or exceeded.
Press the number "5" on the keypad and the display will read "FORCE Y" or "FORCE N", depending on the current
state. Pressing the "*" key will toggle the state. Press the "CLR " key to return to "SERVICE MODE".
SET PRICE
Allows setting of regular prices for an individual item, a complete tray, or the entire machine.
Press the number "7" on the keypad and the display will scroll "SET REGULAR PRICES" once, then "$00.00'" will
be displayed. Prices are entered using the numbers on the keypad and will shift in from the right as numbers are
pressed.
Price setting is covered in detail in the INITIAL PROGRAMMING section of this manual. See pages 36, 37, and 38.
Press the "CLR " key to return to "SERVICE MODE".
SET HAPPY
Allows setting of Happy Hour prices for an individual item, a complete tray, or the entire machine.
Press the number "8" on the keypad and the display will scroll "SET HAPPY HOUR PRICES" once then "$00.00,,
will be displayed. Happy Hour prices are entered in the same way as regular prices. Refer to price setting in the
INITIAL PROGRAMMING section of this manual. See pages 40 and 41. Press the "CLR " key to return to
"SERVICE MODE".
TEST VEND
Allows the service technician to test vend any item.
Press the number “9” on the keypad and the display will read “ITEM”.
Select the item/column to be tested by pressing the corresponding keys on the keypad (i.e. A6), and the
corresponding solenoid will cycle. Press the "CLR " key to return to "SERVICE MODE".
CLEAR ERRORS
Allows the service technician to clear any recorded errors.
Press the number “0” on the keypad and the display will read “CLEAR ERRORS * = Y”.
Press the “*” key and the errors are cleared and the display returns to SERVICE MODE.
To Next Page
Loading...
