Page 18
SETUP MODE
Enter SETUP MODE by opening service door and pressing the Mode Selection button three times. The display will
read "SETUP MODE".
NOTE: Several areas in the SETUP MODE are password protected, when entry into one of these areas is
attempted the display will read "PW". The password must be entered at this point before the service
technician is allowed to proceed. The password need only be entered once during a service call provided
the service door is not closed. If the door is closed and then reopened the password must be reentered
before accessing a protected area. Factory default password is 0000.
The display will show *'s as the password is entered, when the last character is entered the display will read "OK",
then will shift into the requested area. If the display reads "BAD" after the last character is entered it means the
password was not accepted.
ENTER MESSAGE (PASSWORD REQUIRED)
Allows the entry of a custom idle message to replace the default idle message.
Press the letter "B" on the keypad and "ENTER MESSAGE" will scroll across the display. Press the "*" key and the
display will read "PW". Enter the password, the display will read "OK" momentarily then will read "A". The program
is now ready to accept the new message. The "A" key will move forward through the alphabet, numbers, space,
punctuation marks, and an &, and the "B" key will move backwards through the same list. When the desired
character is displayed in the extreme right hand spot press the "*" key. That character is now entered and the
display moves to the left one space as the new message is built. When the new message is complete press the
"CLR" key. This will return to "SETUP MODE".
CLEAR MESSAGE (PASSWORD REQUIRED)
Allows the service technician to clear any custom idle message and return to the default idle message.
Press the letter "C" on the keypad, "CLEAR MESSAGE * = Y", will scroll across the display. Press the "*" key, the
display will read "PW" Enter the password, the display will read "OK" momentarily then will return to "SETUP
MODE". Note: If password was entered prior to this function, when the "*" key is pressed, the message is cleared
and will return to "SETUP MODE".
CLEAR COOL DOWN (PASSWORD REQUIRED)
Allows the service technician to stop a cool down period prior to the set time duration.
Press the letter "E" on the keypad, "CLEAR COOL DOWN * = Y" will scroll across the display. Press the "*" key, the
display will read "PW". Enter the password, the display will return to "SETUP MODE". Note: If password was
entered prior to this function, when the "*" key is pressed, the cool down period is stopped and will return to "SETUP
MODE".
To Next Page
Loading...
