22 XT30/XT50 User Guide Arming and Disarming
Sensor (Fire) Reset Function
System Operation: Area, Home/Sleep/Away, or All/Perimeter.
You can use the Sensor (Fire) Reset, shortcut key 2, when the
system is armed or disarmed. When pressed, detectors that have
latched due to an alarm condition are now restored and returned
to normal function. The keypad displays SENSORS ON and SENSORS
OFF to acknowledge the shortcut key press.
Note: You are prompted to enter your User Code on Area or All/
Perimeter systems.
Monitor (Chime) Function
System Operation: Area, Home/Sleep/Away, or All/Perimeter.
You can use the Monitor (Chime), shortcut key 5, when the system
is disarmed. When pressed, the Zone Monitor operation is initiated.
As needed, refer to the Zone Monitor section. The keypad displays
MONITOR ON and chimes or displays MONITOR OFF and no tone is
sounded.
Note: The Monitor (Chime) shortcut key applies to all Exit zones in
an Area system and to all zones assigned to the perimeter in
a Home/Sleep/Away or All/Perimeter system.
Check-in Report (Latch Key) Function
System Operation: Area, Home/Sleep/Away, or All/Perimeter.
Your system may be pre-programmed at installation to send
messages to your personal email, PDA, or cell phone. You can use
the Check-in Report (Latch Key), shortcut key 4, to have a Check-
in Report message sent. Refer to Appendix D for Email/Cell phone
message information.
Note: Check-in report function is not supported by Icon keypads.
Easy Exit™ Function
System Operation: Home/Sleep/Away.
You can use the Easy Exit shortcut key 8, when the system is
armed, to restart the exit delay allowing you to exit the premises
without disarming the system. For example, you can let a pet out
or retrieve the newspaper. After the exit delay time expires, the
system automatically rearms.
In addition, while the exit delay countdown is running, you can also
press the Easy Exit shortcut key 8 again to cancel the exit delay
countdown. For example, the telephone rings before you retrieve
the newspaper so you press shortcut key 8 to rearm the system.
To Next Page
Loading...
Need help?
General
