40 XT30/XT50 User Guide User Menu
to increment the days of the week. When the correct day
is shown, enter the time you want the burglary protection
to turn on.
6. To clear a schedule, press DELETE and then AM when the
opening time is requested. Press the Back Arrow key to exit
the User Menu.
Extending Schedules
User Code Level: Master only
Function: This option allows users to extend today's programmed
closing time schedule.
Extending a Closing Schedule
1. Access the User Menu.
2. Press the CMD key until SCHEDULES? displays. Press any
select key or area.
3. The keypad displays
PRM EXT OUT FAV.
Select EXT.
The keypad displays – : AM PM. Enter in the new time for
the closing schedule to expire.
Output Schedules
User Code Level: Master only.
Setting Output (OUT) schedules
The Schedules function allows you to set up a schedule for each
of the four outputs connected to your system to turn ON and OFF
automatically.
1. Access the User Menu.
2. Press CMD until SCHEDULES? displays. Press any select key
or area.
3. The keypad displays
PRM EXT OUT FAV.
Select OUT.
4. At the OUTPUT NO: – display, enter the output number you
want to program. Press the CMD key.
5. The keypad displays SUN MON TUE WED. Press the CMD key
to display THU FRI SAT.
6. Select the day you want to program.
Note: After selecting the day of the week for the schedule to
occur, the keypad displays any currently programmed ON OFF
times previously set for that day. This feature allows you to review
programmed schedules at any time.
7. If ON OFF times display, the keypad then displays DELETE
KEEP. Select DELETE to enter new times.
8. The keypad then displays ON TIME?. This is followed by the
display – : AM PM.
Enter a new output ON time and select AM or PM.
The display changes to OFF TIME?. This is followed by the
display – : AM PM.
Enter a new OFF time for the output.
Enter all schedule times using a 12 hour clock. For example,
to enter 6 AM you would enter a 0 + 6 + 0 + 0 and Select AM.
For 11 PM you would enter a 1 + 1 + 0 + 0 and Select PM.
9. The keypad returns to the day of the week display allowing
you to enter another Output schedule. To exit the user
menu or to go back to the SCHEDULES? display, press the
Back Arrow key.
10. To clear a schedule press DELETE and then AM when the
opening time is requested.
Adding a Sunrise/Sunset Output Schedule
User Code Level: Master only.
1. Access the User Menu.
2. Press the CMD key until SCHEDULES? displays. Press any
select key or area.
3. Press CMD to display SUNRISE SUNSET.
To Next Page
Loading...
Need help?
General
