Appendix D XT30/XT50 User Guide 57
MyAccess™ Text Messaging CMDs
Your system may be programmed to allow simple text messages to
be sent to the security system and perform basic user operations.
By texting a message from your cell phone or PDA, the following
actions can be performed: Arm/Disarm, Cancel Alarm, turn Outputs
On/Off, and check Armed Status.
The user that is texting CMDs to the system must have the authority
to perform the CMDs as if it occurred at the keypad. The cell phone
number and user numbers are setup during programming.
After programming is completed, you will receive a welcome message
text from the panel. Write down the phone number that the message
comes from. This will be the number you use to text user operations
to the system.
Note: When texting CMDs listed below, the CMDs can be either
upper or lowercase.
A list of text CMDs can be obtained by texting “help” to the system
phone number. Store this number in your cell phone and write the
number on the Quick Reference Wallet Card located at the back of
this manual.
Arming All Areas with Text Message CMDs
1. Text message your system panel with the following CMD:
• ARM, AWAY, or ALL: To arm all areas, depending on your
system
Arming Partial Areas with Text CMDs
1. Text message your system panel with the following CMD:
• SLEEP: To arm the perimeter and interior of a Home/
Sleep/Away system.
• HOME: To arm just the perimeter of a Home/Away/Sleep
system.
• PERIM: To arm the perimeter of an All/Perimeter system.
• ARM “Area Number” or ARM “Area Name”: To arm specic
areas of an Area system.
The NAME should identify the area name. The NUMBER should
identify the area number. Names and numbers can be mixed, and a
comma should separate the areas. If ARM is sent without any other
words, all areas are armed.
If the system is already armed, you can arm it again only if you are
arming more areas than were originally armed.
Disarming All Areas with Text Message CMDs
1. Text message your system panel with the following CMD:
• DISARM: To disarm all areas.
Disarming Partial Areas with Text Message CMDs
1. Text message your area system panel with the following CMD:
• DISARM “Area Number” or DISARM “Area Name”: To disarm
specic areas
of an Area system.
The NAME should identify the area name. The NUMBER should
identify the area number. Names and numbers can be mixed, and
a comma should separate the areas. If DISARM is sent without any
other words, all areas will be disarmed.
If the system is already disarmed, you will receive a message saying
that the system is already disarmed.
To Next Page
Loading...
Need help?
General
