User Menu XT30/XT50 User Guide 39
Schedules
User Code Level: Master only.
Function: The Schedules function allows you to program the times
at which you normally turn your burglary protection on and off
each day of the week. This information can then be used by the
system to automatically arm or disarm the burglary protection.
Your system may be pre-programmed at installation to allow
automatic arming and disarming. When programmed, you can
enter a schedule for the arming and disarming times.
You can also use the Closing Check/Extend feature with Schedules
to ensure your system is armed by an authorized user at a specic
time. This option sounds the keypad buzzer and displays CLOSING
TIME! when a schedule expires. Users still on the premises are
required to arm the system or extend the schedule. If the system
is not armed, or the schedule not extended, a report can be sent
to the central station and/or an email address or cell phone.
When a schedule expires and CLOSING TIME! displays, the keypad
next displays ENTER CODE: -. To silence the keypad buzzer and
extend the schedule for one hour, a user must either enter a valid
user code or present a card to the card reader.
Also, when a closing schedule expires, your system may turn on
the Late to Close Output. This output turns off anytime your
system is armed, or a schedule is extended or changed. See
System Setup for Output information.
Your system provides you with three different types of schedules:
Permanent schedules are used for automatic arming and
disarming and always occur at the same time until you change or
delete them.
Extend schedules allow an authorized user to extend the present
day's permanent scheduled closing time.
Favorite schedules are used for automatically activating the
devices in a Favorite and always occur at the same time until
you change or delete them. See System Setup for Favorite
information.
Sunrise/Sunset schedules use local weather information to stay
synced with sunrise and sunset times throughout the year. You can
set the schedule to activate or deactivate 5, 10, 15, 30, 45, or 60
minutes before or after sunrise or sunset. Only one Sunrise and one
Sunset time can be saved per schedule.
Note: A weather zip code must be entered in SYSTEM OPTIONS for
this option to be available.
XT50 Series Panels Only:
Output schedules are used for automatically turning your system
outputs ON and OFF and always occur at the same time until you
change or delete them. See System Setup for Output information.
Permanent Schedules
User Code Level: Master only.
1. Access the User Menu.
2. Press the CMD key until SCHEDULES? displays. Press any
select key or area. The keypad displays PRM EXT OUT FAV.
Select PRM.
3. The keypad next displays the day of the week you want the
schedule to start as SUN MON TUE WED. Press the CMD
key to show the remaining days of the week and then Select
the start day.
4. The keypad displays OPENING TIME?. Press CMD. The keypad
now displays MON – : AM PM. Enter the time you want the
burglary protection to be turned off. Use a 12 hour clock
only (12:00 to 11:59). Select AM or PM.
5. The keypad then displays CLOSING TIME?. Press the CMD
key. The keypad then displays MON – : AM PM. If you
want the schedule to be for consecutive days, Select MON
To Next Page
Loading...
Need help?
General
