User Menu XT30/XT50 User Guide 37
10. Select the authority level to assign to the user code.
11. The following options can be selected for user codes with
non-Master authority levels:
11a. TEMP CODE NO YES.
Select NO to make this a permanent user code.
Select YES to make this a temporary code. The
keypad displays TEMP DAYS: - . Enter the number
of days (1 to 250) that the temporary use code can
operate. Default is seven days. Temporary users
are deleted from the system at 12:00 AM on the
last day. You can delete a Temporary user code at
any time before the programmed period ends.
11b. AREAS: (Displays in Area systems only).
Enter the area numbers where this user is to have
access. For example: if you want this user to only
have access to areas 1 and 2, enter the numbers
1 and 2. Once the correct area numbers display,
press CMD.
11c. ARM ONLY NO YES.
Select NO to allow this user to arm and disarm the
system and access all Standard level functions in
the User Menu. Select YES to restrict this user to
arming only. The Arm Only user code can bypass
zones not in a normal condition at the time of
arming.
12. At the USER CODE IN LOCK? NO display, choose whether or
not the user code is stored in all compatible Z-Wave Doors.
Press the third top row select key or area for NO or the
fourth top row select key or area for YES. Then, press CMD.
Note: This option is only available for user codes 2-20. Once
the user code has been received by the lock, entering it at
the lock will lock the door or unlock the door and disarm
the system depending on the user’s privileges.
Adding User Codes
User Code Level: Master only.
1. Access the User Menu.
2. Press the CMD key until USER CODES? displays.
3. Press any select key or area.
The keypad displays ADD DEL CHG.
4. Select ADD to add a new user code.
5. At the USER NUMBER: — prompt, enter a user number and
press CMD.
6. The displays changes to CODE NO:. Enter the four-digit user
code and press CMD.
This is the number the user enters each time they arm,
disarm, or make changes to the system.
If the code you entered is already in use, or is a code used
internally by the system, the keypad displays ALREADY IN
USE. You must enter a different 4-digit user code.
7. A 16-character name may be entered to identify the user.
Press any top row key to clear the current text “user name”.
You may then enter the new name. After entering the name
press CMD. See Entering Names in Appendix C.
FOR XT30 Panels:
8. The display changes to MASTER? NO YES. Select YES to
make this a Master user level with the authority to access
all User Menu functions.
Select NO to make this a Standard user level. Default is set
to NO. Proceed to step 11a.
FOR XT50 Panels:
8. The display changes to LEVEL: STANDARD
9. Press any select key or area. The keypad displays
SCH LTD STD MSTR.
To Next Page
Loading...
Need help?
General
